Water Right Impression Series Troubleshooting Guide download pdf (Page 12)

PROBLEM CAUSE CORRECTION

1. No display on

PC board

A. No power at electric outlet A. Repair outlet or use working outlet

B. Control valve power adapter not plugged into

outlet or power cord end not connected to PC

board connection

B. Plug power adapter into outlet or connect

power cord end to PC board connection

C. Improper power supply

C. Verify proper voltage is being delivered to

PC board

D. Defective power adapter D. Replace power adapter

E. Defective PC board E. Replace PC board

2. PC board does not

display correct time

of day

A. Power adapter plugged into electric outlet

controlled by light switch

A. Use uninterrupted outlet

B. Tripped breaker switch and/or tripped GFI B. Reset breaker switch and/or GFI switch

C. Power outage

C. Reset time of day. If PC board has battery

back up present the battery may be depleted.

See front cover and drive assembly drawing

for instructions.

D. Defective PC board D. Replace PC board

3. Display does not

indicate that water is

flowing. Refer to user

instructions for how the

display indicates water

is flowing.

A. Bypass valve in bypass position

A. Turn bypass handles to place bypass in

service position

B. Meter is not connected to meter connection on

PC board

B. Connect meter to three pin connection labeled

METER on PC board

C. Restricted/stalled meter turbine

C. Remove meter and check for rotation or

foreign material

D. Meter wire not installed securely into three

pin connector

D. Verify meter cable wires are installed securely

into three pin connector labeled METER

E. Defective meter E. Replace meter

F. Defective PC board F. Replace PC board

4. Control valve

regenerates at wrong

time of day

A. Power outage

A. Reset time of day. If PC board has battery

back up present the battery may be depleted.

See front cover and drive assembly drawing

for instructions.

B. Time of day not set correctly B. Reset to correct time of day

C. Time of regeneration set incorrectly C. Reset regeneration time

D. Control valve set at “on 0” (immediate

regeneration)

D. Check programming setting and reset to

NORMAL (for a delayed regen time)

E. Control valve set at “NORMAL + on 0”

(delayed and/or immediate)

E. Check programming setting and reset to

NORMAL (for a delayed regen time)

5. Time of day flashes on

and off

A. Power outage

A. Reset time of day. If PC board has battery

back up present the battery may be depleted.

See front cover and drive assembly drawing

for instructions.

6. Control valve does not

regenerate automatically

when the correct button(s)

is depressed and held.

For timeclock valves the

buttons are s & t.

For all other valves the

button is REGEN.

A. Broken drive gear or drive cap assembly A. Replace drive gear or drive cap assembly

B. Broken piston rod B. Replace piston rod

C. Defective PC board C. Defective PC board

TROUBLESHOOTING GUIDE

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Comments to this Manuals

No comments

Water Right Impression Series Troubleshooting Guide Page 12

Comments to this Manuals

Related products and manuals for Water dispensers Water Right Impression Series