Water Right Impression Series Troubleshooting Guide download pdf (Page 7)

TIME HOUR

SET

2:00

1. Set time of day:

1 2

TIME MINUTES

SET

CURRENT DAY

SET

MON

PROGRAMMING PROCEDURES:

NOTE: The manufacturer has preset the unit so that the gallons between regenerations will be

automatically calculated after the hardness is entered.

STEP 1 – Press next and + simultaneously for 3 seconds.

STEP 2 – HARDNESS: Set the amount of hardness in grains per gallon (default 20) using

the + or — buttons. The allowable range is from 1 to 150 in 1 grain increments.

Note: If a resin media is used in the softener, increase the grains per gallon if soluble

iron is present (1ppm = 4 gpg). This display will show “–nA– (not available)”

if “FILTER” is selected or if “AUTO” is not factory set.

Press next to go to step 3. Press regen if you want to exit.

STEP 3 – DAYS BETWEEN REGENERATION (DAY OVERRIDE): The manufacturer has factory

set 6 DAYS as the default. This is the maximum number of days between regenerations. If

this is set to “OFF”, regeneration initiation is based solely on gallons used. If any number is

set (allowable range from 1 to 28), a regeneration initiation will be called for on that day

even if a sufficient number of gallons were not used to call for a regeneration.

Set Day Override using + or — buttons (6 is recommended):

• set number of days between regeneration (1 to 28); or

• set to “OFF”

NOTE: This valve has the capability of regenerating up to six times in

one day. This can be observed by using the — button to toggle below

once a day regeneration (see example to right). These settings are

typically used in twin system configurations or in commercial settings.

Press next to go to step 4. Press regen if you need to return to the

previous step.

2. Programming:

Time of day should only need to be set after extended power outages or when daylight saving time begins

or ends. If an extended power outage occurs, the time of day will flash on and off indicating that the time

should be reset.

STEP 1 – Press set clock.

STEP 2 – CURRENT TIME (HOUR): Set the hour of the day using + or — buttons.

AM/PM toggles after 12. Press next to go to step 3.

STEP 3 – CURRENT TIME (MINUTES): Set the minutes using + or — buttons. If it is desired to

back up to the previous step press regen button once. Press next to go to step 4.

STEP 4 – CURRENT DAY: Set the day of the week using + or — buttons. Pressing next will exit

set clock and return to the general operating display (page 10).

REGENS/DAY REGEN

SET

4 / DAY

Example: Indicates unit set

to regen 4 times in one day.

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comments to this Manuals

No comments

Water Right Impression Series Troubleshooting Guide Page 7

Comments to this Manuals

Related products and manuals for Water dispensers Water Right Impression Series